Circle trouble - beginning and end are offset - LightBurn Hardware Compatibility - LightBurn Software Forum

Hello, I read lots of posts regarding Circles not round and do not meet but couldn’t see the same issue I experience. I am new to laser cutting and just assembled a Sculpfun S30 Pro (10W) with Y axis extension. When engraving / cutting the first test pattern, the cut circles are oval and there are strange lines off the circles (and rectangles too). I run some additional tests just on the cutting after adjusting the Y axis belt, but it made no difference. I then used LaserGRBL to make t

Using offset circle with fill - nothing seems to happen but preview looks fine - LightBurn Software Questions - LightBurn Software Forum

Lightburn move panel issue - LightBurn Hardware Compatibility - LightBurn Software Forum

Circle trouble - beginning and end are offset - LightBurn Hardware Compatibility - LightBurn Software Forum

Trouble aligning camera - LightBurn Hardware Compatibility - LightBurn Software Forum

Homeing with X-Y and Z axis - Ruida controllers - LightBurn Software Forum

XTool/Lightburn - LightBurn Hardware Compatibility - LightBurn Software Forum

Frameslop Error - LightBurn Hardware Compatibility - LightBurn Software Forum

Circle trouble - beginning and end are offset - LightBurn Hardware

Lightburn Camera 8MP 120-W cannot complete calibration - LightBurn Hardware Compatibility - LightBurn Software Forum

Lightburn Line and Fill don't match - xTool D1 - LightBurn Software Forum

Rotary table not recognized in light burn - Ortur Lasers - LightBurn Software Forum

Circle trouble - beginning and end are offset - LightBurn Hardware Compatibility - LightBurn Software Forum