DA Dumbbell Mold – Stix and Stone

MOLD ONLY. Sized to create hex head dumbbells ranging from 5-50 lbs. Place a steel pipe of your choosing on the center index and pour concrete to your desired weight and let cure*. Remove, flip and repeat. Mold is not marked so you can place your own numbers for each dumbbell.  Supplies you'll need to buy: concrete, st

MOLD ONLY. Sized to create hex head dumbbells ranging from 5-50 lbs. Place a steel pipe of your choosing on the center index and pour concrete to your desired weight and let cure*. Remove, flip and repeat. Mold is not marked so you can place your own numbers for each dumbbell. 

Supplies you'll need to buy: concrete, steel pipe, 4 screws & rebar tie wire.

*CURING: Concrete takes 24-48 hours to set. For optimal results, de-mold after this time and continue letting your dumbbell cure. Most concrete mixes reach 70% of specified compressive strength after 7 days and full strength at 28 days.

**Dumbbells not included; shown for display.**

MOLD ONLY. Sized to create hex head dumbbells ranging from 5-50 lbs. Place a steel pipe of your choosing on the center index and pour concrete to your desired weight and let cure*. Remove, flip and repeat. Mold is not marked so you can place your own numbers for each dumbbell.  Supplies you'll need to buy: concrete, steel pipe, 4 screws & rebar tie wire. *CURING: Concrete takes 24-48 hours to set. For optimal results, de-mold after this time and continue letting your dumbbell cure. Most concrete mixes reach 70% of specified compressive strength after 7 days and full strength at 28 days. **Dumbbells not included; shown for display.**

Rock Weights 60 lb Dumbbell Mold (Single) : Sports & Outdoors

diy concrete dumbells Online Shopping

Dumbbell Mold

Gorilla Weight Dumbbell Plate Mold Kit, 49% OFF

Rock Weights 60 lb Dumbbell Mold (Single) : Sports & Outdoors

Stix and Stone Make Concrete Weights with the DA Plate Mold

Stix And Stone

ST8203 = Separating Discs 7/8 x .025 Double Sided (pkg/100) - FDJ Tool

Stix and Stone, Make Concrete Weights with the DA Plate Mold