Extruder keeps slicing the filament. This print has a ton of retraction. Should I just lower the retraction rate significantly or is there a way to loosen the group between the extruder

Which way for retraction?

Help with my filament dryer setup : r/3Dprinting

Does filament tend to be worse towards the end of the spool? : r/3Dprinting

How to fix under extrusion after travel - 3D Printing - Cookiecad

I hate the filament runout sensor on the ender 3 max. I feel the need to unscrew it everytime I need to jam the filament through it because it wont go in

How to Adjust Retraction Distance to Prevent Oozing

Limit extruder feedrate for printing and retraction · Issue #5248

I hate the filament runout sensor on the ender 3 max. I feel the need to unscrew it everytime I need to jam the filament through it because it wont go in normally. am I the only one with this problem? is there a way to fix this issue? : r/ender3

Found this screw halfway out in the middle of a print job. Is this

10 Advanced 3D Slicer Settings That Will Save Your Prints